Howard Miller Chronometer Owners Manual

Posted on February 18, 2016 | By clockde

HOWARD MILLER QUARTZ CHRONOMETER ALARM CLOCK

OPERATING INSTRUCTIONS

STARTING

A battery is included with your clock. To start your clock:

1. Turn the two thumb screws (A) on the back of the clock and remove the rear cover.
2. If the battery is already installed, remove the plastic strip, which is included to preserve battery life in storage.
3. If the clock does not start, check that the battery is correctly installed and that the (+) and (-) symbols on the battery match those in the battery holder.

TIME SETTING

1. Slide the alarm on/off switch (B) down, to the off position.
2. Gently pull out and turn the set knob (C) in the direction indicated by the arrow.
3. After setting the time, push the set knob back in.

ALARM SETTING

1. Slide the alarm on/off switch (B) down, to the off position.
2. Make sure the set knob (C) is pushed in.
3. Turn the set knob (C) to set the alarm hand to the desired alarm time.
4. Slide the alarm switch (B) up to the on position.

BATTERY REPLACEMENT

When your clock stops, begins to lose time, or the alarm volume becomes weak,  replace the battery with a fresh 1.5 volt “AA” size battery.

Howard Miller Chronometer for Sale

It is recommended to always use Duracell brand batteries in all clocks of this type to reduce the possibility of leakage.

Posted in Clock Help and Instructions